DVTEL ioimage CT-5320F, Быстрое руководство по установке

Страница: 17 / 27

Installation and Mounting
9
Attach an RJ45 connector to the Ethernet cable.
Pull the cables tightly back through the camera, exposing the thread of
the cable sealing gland out of the base of the camera.
Attach the electrical nut back onto the gland.
Tighten the nut securely until it is finger-tight.
Use the hex wrench to tighten the electrical nut to approximately
8 in-lbs. (0.9 newton meters) of torque.
Figure 9: IP66 Enclosure with PoE Connection
Note:
To ensure a proper earth ground between the camera and a PoE
switch, we strongly recommend using Shielded Twisted Pair (STP)
cabling. Installations of ioimage Thermal cameras with STP cabling
and a properly earth grounded PoE switch are tested to comply with
industry immunity standards for Electro Static Discharge. Any other
installation method may leave the camera at risk and void the
warranty.