DVTEL ioimage CT-5320F, Быстрое руководство по установке

Страница: 7 / 27

Document Information
vii
Camera Warnings
Warning:
1. Only qualified trained personnel should service and repair this
equipment.
2. Observe local codes and laws and ensure that installation and
operation are in accordance with fire, security and safety
standards.
3. The unit’s cover is an essential part of the product. Do not
open or remove it. Operating the unit without the cover poses
a risk of fire and shock hazards
.
4. Do not disassemble the unit or remove screws. There are no
user serviceable parts inside the unit.
5. Operating the camera at voltage levels outside the specified
range may result in permanent damage to the unit and void the
product warranty.
6. The camera electronics and electronic interfaces are sensitive
to electrostatic discharge. Follow appropriate ESD procedures
when handling the camera and during installation.
7. Be sure not to expose the camera head to strong sunlight,
which could cause the camera to overheat.
8. This product must be connected to a Power over Ethernet IEEE
802.af-compliant power source or a UL listed Class 2 power
supply rated 12-24 VDC or 24 VAC, minimum 13W or 0.54A.
9. For PoE installations, we strongly recommend using STP cabling
and an earth grounded end point to ensure proper ESD
immunity. For installations powered by AC or DC, a properly
earth grounded power source is strongly recommended. Any
other installation method may leave the camera at risk and
void the warranty.
10. If you use a power supply, make sure that the connection
matches the positive and negative polarity on the unit, and
protect against static electricity, ground faults and power
surges.