
Rear-Seat Entertainment
30
Information
Troubleshooting
CAUTION
If you encounter a problem, please turn the power
off, then on again. If the unit is still no functioning
normally, please review the items in the following
checklist. This guide will help you isolate the
problem if the unit is at fault. Otherwise, make
sure the rest of your system is properly connected
or consult your authorized dealer.
No function or display.
Vehicle’s ignition off.
- If connected following the instructions, the unit
will not operate with the vehicles ignition off.
Improper power lead connections.
- Check if the power lead is properly connected.
No fuse or blown fuse.
- Replace the fuse on the battery lead of the unit
with the proper value.
Vehicle’s battery is weak.
- Check the voltage of vehicle’s battery.
Disc playback sound is wavering.
Moisture condensation in the disc unit.
- Allow enough time for the condensation to
evaporate (about 1 hour).
Disc insertion is not possible.
A disc is already in the DVD player.
- Eject the disc and remove it.
The disc is being improperly inserted.
-Reinsert the disc following the instructions in the
“Loading and Unloading Discs” section. (Page 7)
Unable to fast-forward or fast-reverse the disc.
The disc has been damaged.
- Eject the disc and discard it. Using a damaged disc
in your unit can cause damage to the mechanism.
Disc playback sound skips due to vibration.
Improper mounting of the unit.
- Securely re-mount the unit.
The disc is very dirty.
- Clean the disc
The disc has scratches.
- Change the disc.
The pick-up lens is dirty.
-Do not use a commercial available lens cleaner
disc. Consult your nearest dealer.
Disc playback sound skips without vibration.
Dirty or scratched disc.
- Clean the disc. Damaged disc should be replaced.
CD-R/CD-RW playback is not possible.
Close session (finalization) has not been performed.
- Perform finalization and attempt playback again.
Error displays
Mechanical error
- Press
EJECT
. After the error indication disappears,
insert the disc again. If the above mentioned
solution does not solve the problem, consult your
nearest dealer.
Unit does not operate.
Monitor’s power is not turned on.
- Turn on the monitor power.
Condensation
-Wait a while (about 1 hour) for the condensation to
dry.
No picture is produced.
Monitor’s mode is not switched to the mode you
want to see.
- Switch to the mode you want to see.
Monitor’s parking break cord is not connected.
- Connect the monitor parking brake cord and set the
parking break. (For details, refer to the monitor
instruction.)
Brightness control is set for minimum brightness
control.
- Adjust the brightness.
Incorrect setting of the mode.
- Switch to the correct mode.
- Check the connection to the source unit.
- Check the power of the source unit.
Incorrect or open connection with the Monitor, AV
interface unit.
- Check the connection and remedy.
Playback does not start.
Disc is loaded upside-down.
- Check the disc and load it with the label side facing
upward.
The disc is dirty.
- Clean the disc.
A disc not able to playback with this unit is loaded.
- Check if the disc is able to be played back.
Parental lock is set.
- Cancel the parental lock or change the rating level.
Setup menu is displayed.
- Press to turn the menu off.
SETUP
Содержание TH102MS
Страница 34: ...Seat Back Monitor 33...
Страница 35: ...34 Rear Seat Entertainment...
Страница 36: ...DVS MS 980916 v0924...