
24
Rear-Seat Entertainment
Installation and Connections
2.
Without Seatback Cover
1) Stick the marked with sticker on the position you
would like to cut.
2) According to the marked with sticker to cut a 2.4cm
hole in the top of the seatback, and then insert the
base of cover into the hole. (Figure 6-2)
3) Push the Power Cables into the seat slowly.
If any obstructions encountered, pull back slightly
on the cable and rotate it before continuing.
4) Route the Cables so that they exit the bottom of
the seatback. (Figure 6-3)
(Figure 6-3)
6
Route power cable
Before install power cable, make sure if there have
seatback cover in your car seat. Please choose
a way to route the power cable.
1.
Seatback Cover
Remove the seatback cover carefully. Place the
Power cable inside the seatback, and then put
the cover back to the seat. (Figure 6-1)
(Figure 6-1)
Power Cable
Seatback Cover
※
Please gap downward.
Konb
Slide Rail
Monitor
(Figure 5)
5
Install and fix the monitor
Slide the monitor into slide rail. Then adjust the
monitor to the best position and tighten the konb.
(Figure 5)
If you have installed the base of
cover, please put the cover on the
cover bass when not being used.
CAUTION
(Figure 6-2)
Marked with sticker
Base of cover
※
Gap
Содержание TH102MS
Страница 34: ...Seat Back Monitor 33...
Страница 35: ...34 Rear Seat Entertainment...
Страница 36: ...DVS MS 980916 v0924...