Dutch Pinball DP-069, Техническая поддержка

Страница: 73 / 146

Dutch Pinball – Technical Support TBL FAQ rev 0.51
Page 73 MPF removal and installation guide rel 0.53
MPF back in the TBL
Step 5 – Re-install MPF
•
Take the MPF and place the MPF mounting screw which is under the loopramp already in
place in the hole. Once the MPF is in place it will otherwise be impossible to get this screw in
place. Hold MPF slightly vertically abov
e the place where it’s going to be installed
•
If you have the built type B with an opto cable guide this cable coming from the opto’s of the
scoop through the same hole as the flatcable. If you have type A you can skip this step.
•
Make sure the cabling is flush against the underside of the MPF. IF its not flush with the MPF
it can block the Jesus lane.
•
Plug now the plug of the stepper motor cable in place in the stepper motor and do the same
with the flat cable in the PCB. Put MPF in place on his mounting rests and make sure no cable
is de-attached and comes in a place where it can obstruct the ball.
picture of cabling with built type B