Inspection
Regularly check the device for damage and wear. If damage occurs, these must be repaired by a Dustcontrol service technician
or by a service workshop authorized by Dustcontrol.
Intended use
Dustcontrol’s filter cyclones are used to filter dust that arises in an industrial environment.
The filter cyclone is connected to a piping system provided by Dustcontrol. The system is in turn connected to a vacuum
generator.
Functional description
S34000 EX purifies the air in two steps.
In the first step, dust is separated in the cyclone. The air is taken in tangentially into the filter cyclone and begins to circulate
powerfully. This causes the particles to be pressed out against the casing surface and then fall to the bottom.
In the second step, the air passes through a fine filter.
At a signal from the control system, the filters are automatically cleaned by means of an air pulse in the opposite suction direction.
This results in extremely effective cleaning whilst being gentle on the filters. When the filters are cleaned, a number of very clearly
audible air shocks will be heard at intervals of a number of seconds.
S34000 EX is composed of modules and can be fitted in several different ways. The inlet can be twisted and turned to allow the
filter cyclone to fit into the premises.
Above: an example of how to configure a filter cyclone
For ATEX-classified filter cyclones, separated material must be collected in a container.
Installation
The following describes how to assemble the product:
1. Fit the bottom cone onto the legs.
Adjust the height of the legs depending on which discharge cone/container is selected.
14
S34000 EX, Art no. 99060-A
ENGLISH
Содержание 99060-A
Страница 82: ...S34000 EX Art no 99060 A ...
Страница 83: ...S34000 EX Art no 99060 A ...