DUROPRO PM3000, Инструкция по эксплуатации

Страница: 8 / 12

8
and is suggested to be
mounted as shown in Pic B.
(C) If the difference between
the Front mount holes
and the distance between
the rear mount holes is
greater than 40mm on the
mitre saw, then the off set
brackets (8) are required
and is suggested to be mounted as shown in Pic C.
To Fit the Off set brackets, place the 20mm Coach bolt
through the off set bracket from the BOTTOM and fit the
washers and nut on the TOP of the bracket. Secure the nut
with 3 turns. (Fig D)
Align the head of the coach screw with the round hole
in the quick attach machine
mounts (5) (Fig E), place the
head through the hole and
then slide the off set bracket (8)
assembly along the slot in the
quick attach machine mount
(5). (Fig F)
It is suggested to leave the
assembly loose at this stage
Mounting the saw.
1. Measure the distance between the front mounting holes
of the saw and compare with the distance between the
rear mounting holes. Using the above guide to determine
if the quick attach mounts (5) will be set up with A, B,
or C.
2. If the off set brackets (8) are to be used, fit the off set
brackets (8) as B, or C.
3. Attach the quick attach machine mounts (5) to the Top
Stand Frame.
4. Space the quick attach machine mounts (5) apart so the
saw mounting holes will align with the slot in the quick
attach machine mount on one side and then the off set
brackets (8) on the other or in the case of (A), both slots
of the quick attach machine mounts (5). After setting the
position of the off set brackets (8), finger tighten the nuts,
but still allow the brackets to slide a little on the quick
attach machine mount.
5. Pick up the saw and sit the saw on the mounts.
6. Using the 4 x 45mm Coach bolts supplied, mount the
saw with the heads of the bolts either in the slot of the
quick attach machine mounts (5), or under the surface of
the off set brackets (8).
7. Leave all bolts loose and align the saw with the stand.
There is enough movement to have the saw at right
angles with the stand. ENSURE the quick attach machine
mounts (5) are at right angles with the top stand frame.
8. Tighten all bolts firmly.
Set-up / Knockdown Procedure
Before storing or transporting, make sure all
attachments are secured. Collapse outrigger supports.
It is recommended that benchtop tools are removed by
disengaging the quick attach machine mounts from the
stand, but leave the mounts on the appliance.
C
D
F E