DUROPRO PM3000, Инструкция по эксплуатации, Страница: 7 / 12

7
Fitting the Quick Attach machine mounts to
the top stand frame.
The quick attach machine mounts are designed to be able
to be quickly fitted and quickly removed.
To fit the quick attach machine mounts:
1. Locate the heel of the quick machine mount (5) around
and under the rear end of the top stand frame as shown
in Fig A.
2. With the mount spring lever(6) compressed, rotate the
quick machine mount (5) downwards to towards the top
frame stand. As the spring loaded lever (6) passes the
top of the stand, release the lever. Continue to push
downward until the spring loaded lever “CLICKS” into
place. (Fig B)
3. The quick machine mount (5) should now be locked in
place. (Fig C)
4. Always check the quick machine mount (5) is locked by
applying a force upward at the front of the quick attach
machine mount (5).
To remove the quick Attach machine mounts (5), compress
the mount spring lever(6) and lift.
NOTE: If there is any appliance on the mounts when
removing, the weight of the appliance will tend to slide
the mounts backward as you lift the front. Be aware of
the weight on the mounts.
Once the mount spring lever (6) has been released, and
then the heel has disengaged, it is best to then lift the
mounts (5) ( and the appliance if fitted) directly from the
stand.
The assembly is designed to mount the saw on the quick
attach machine mounts and the saw and mounts can come
off together, and the mounts can remain on the stand for
storage etc.
Setting up to Mount the saw
The attachments supplied with the stand should allow for
various different footprints to be mounted. In general, the
main difference between mountings is where the distance
across the front mounting holes is different to the distance
between the rear two mounting holes.
(A) If the distance across the
front mount holes is the
same as across the rear
mount holes, you DO NOT
require the use of the
Off set Brackets (8) and
the saw can be mounted
directly on to the quick
attach machine mounts (5).
The mount set up is
as shown in Pic A.
(B) In general, if the difference
between the Front mount
holes and the distance
between the rear mount
holes is less than 40mm on
the mitre saw, then the off
set brackets(8) are required
A
C
B
A
B
D