DUROPRO PM3000, Инструкция по эксплуатации

Страница: 6 / 12

6
Assembly Instructions
Read all assembly instructions completely before attempting
assembly.
See parts list on Page 5 for names and pictures of parts to
identify all components. Do not discard box until after you
have found all the components and completed assembly
Assembling the Stand
1. Place top stand frame (1) upside down on your workbench
or surface, ensuring the surface is even and flat.
2. Note: This stand has 2 legs that are completely straight,
and 2 legs that are slightly curved where they are
connected to the stand
frame.
Push down the snap pin lock
(10) on the leg, and pull out
the leg towards you until the
snap pin locks into place in the
snap pin lock ‑ assembled (11)
position. You will hear a click
when this locks into position.
3. Repeat the process for the straight leg on the opposite
end, and then both the other legs.
4. After ensuring all the legs are locked into position, turn
the stand upright onto its legs on the ground or a flat even
surface.
Installing the Outrigger Supports
1. Insert the outrigger support (3) into the frame end tubing
on the left hand side and position length wise according
to your requirements.
Screw one of the M8 locking knobs (7) supplied into the
threaded hole at the corner of the tube frame and turn
clockwise to secure the outrigger support (3) in place
Repeat on the opposite end.
Installing the Work Supports
1. Insert the work support into the top of the Outrigger
support (3).
2. Position to the height
according to your
requirements and while
holding in place, use your
other hand to screw one of
the M8 locking knobs (7)
supplied into the threaded
hole on the outrigger support
by turning it clockwise to
secure into position.
3. Repeat for the other outrigger support and work support
at the opposite end of the stand.