Duroflame Abel, Руководство пользователя

Страница: 16 / 38

Page 16 from 38

Do not touch parts and surfaces until they have cooled down completely, the
parts and surfaces may still be unstable.

Ventilate the room very well several times after and during the first use.

The initial start-up of the pellet stove can take longer than usual. Because
the mortar has not yet been filled with pellets, it takes longer for the pellets
to reach the burner pot.
It is even possible that it takes too long and the pellet stove will display an
error message (Error1).

In this case, hold down the ON/OFF button for a few seconds and then
restart the pellet stove with the ON/OFF button.
Carry out the following points before starting the pellet stove for the first time:

Ensure that the pellet stove is installed correctly, as described in the previous
sections.

Fill the reservoir with pellets/check that there are pellets in the reservoir.

Check that the burner box is positioned as far back as possible and that the
glow plug is in front of the hole in the burner box.

Check whether the door is closed properly.
4.2.2 Switching on the pellet stove
You do this by means of the power switch. The power switch is the switch that
sits next to where the power cable is plugged in.
Possible malfunction: Fout! Verwijzingsbron niet gevonden. No image
4.2.3 Ignition

Check whether there are enough pellets in the tank.

Check that the burner box is clean, that it is positioned as far back as
possible and that the glow plug is in front of the hole in the burner box.

Check whether the door is closed properly.
To start the stove, press and hold the ON/OFF button for a few seconds until you
hear a beep.
The display of the remote control shows: " fan on ". Now the pellet stove will start and
go through the following steps: