-19-
CAUTION:
Never use “rotation with hammering” mode when the drill chuck assembly is
installed on the tools. The drill chuck assembly maybe damaged. Also the drill
chuck will come off when reversing the tool.
Pressing excessively on the tool with not speed up the drilling. In fact, this
excessive pressure will only serve to damage the tip of your bit, decrease the tool
performance and shorten the service life of the tool.
There is a tremendous twisting force exerted on the tool/bit at the time of hole
breakthrough. Hold the tool firmly and exert care when the bit begins to break
through the workpiece.
A struck bit can be removed simply by setting the reversing switch to reverse
rotation in order to back out. However, the tool may back out abruptly if you do
not hold it firmly.
Always secure small workpieces in a vise or similar hold-down device.
MAINTENANCE
Remove the battery pack from this tool before cleaning solutions.
This tool is lubricated before it leaves the factory. This lubrication
should last for the life of the tool. No further lubrication is required.
CLEANING
With the motor running, blow dirt and dust out of all air vents with dry air at least once
a week. Wear safety glasses when performing this. Exterior plastic parts may be
cleaned with a damp cloth and mild detergent. Although these parts are highly are
solvent resistant, NEVER use solvent.
CHARGER CLEANING INSTRUCTIONS
Dirt and grease may be removed from the exterior of the charger using a cloth or soft
non-metallic brush. DO NOT use water or any cleaning solutions.
WARNING!!:
Disconnect the charger from the AC outlet before performing any
cleaning of the charger.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.
WARNING
NOTE
