Assembling the remaining thread monitor (2-needle machines)
20
Additional Instructions M-TYPE DELTA - 00.0 - 08/2019
Fig. 16: Assembling the remaining thread monitor (3)
10. Screw the sensor block (11) to the right hook support using
the screw (12).
Make sure to use the hole that is closer to the hook.
11. Screw the sensor block (13) to the left hook support using
the screw (14).
Make sure to use the hole that is closer to the hook.
Information
To allow for easier assembly of the RFW sensor blocks, turn the hand-
wheel such that the movable blade can be swung out of the way by hand.
Fig. 17: Assembling the remaining thread monitor (4)
The sensor blocks are positioned correctly when sensor block (13) abuts
on the casting. The light beam of the sensor will then hit the flat of the
bobbin through the slot (15) in the hook housing.
(1) - Hose
(2) - Hose
(3) - Cable RFW sensor left
(6) - Cable RFW sensor right
(11) - Sensor block right
(12) - Screw
(13) - Sensor block left
(14) - Screw
⑪
⑥ ①
⑬
③
②
⑫
⑭
(13) - Sensor block
(15) - Slot
⑬
⑮
