8
TUF 800 CLEAR ROOF PANEL (Optional)
Clear Panel Brace
Roof with Clear Panel:
Handle Clear Panel with care. The Clear Panel will crack if not fitted correctly.
Riveting: Pre-drill 3.3mm hole through Clear Panel and steel.
Nailing: Pre-drill a 6mm hole through Clear Panel. Hammer in nails with caution.
Step 1a:
Pre-drill hole in V at both ends of Clear Panel Brace. Position Clear Panel Brace centrally on Top End
Plates and nail in place using a 30mm clout each end
(fig. 3)
.
Position Roof Sheets as shown in
fig.1
. When fitting Clear Panel ensure it OVERLAPS Roof Sheets. Rivet
sheet joins, one rivet 200mm from edge front and back. When riveting Clear Panel to Roof Sheets use
sealed rivet with steel washer
(fig. 2)
. Fit two more rivets evenly spaced in centre of each join.
fig. 4
fig. 3
=
Rivet
=
Rivet with steel washer
Clear Roof Panel
Step 2a: Rivet Clear Panel Brace to the Clear Panel, pre-drill holes from underneath then rivet down from on top using sealed rivets
with Steel Washers. For riveting detail see
fig. 4
.
