MK1 CLEAR ROOF PANEL (Optional)
Step 1:
Position Roof Sheets at each end. Leave a gap where the Clear Panel is to be fitted. Nail on first Roof Sheet
(refer to step 2 MK1 Roof).
Step 2:
Where the Clear Roof Panel is to be positioned, nail a 45x45mm Bevelled Edge Support on each side of the
Ridge Beam.
(fig. 1)
Step 3:
Position Clear Roof Panel and Flat Roof Sheet (or second Clear Panel). The Flat Roof Sheet underlaps one sheet
and overlaps the other. The Clear Roof Panel OVERLAPS both Roof Sheets. Ensure sheet joins are flush at the
outside edge then rivet flat sheets to pressed sheets. Two rivets per join. Centralise Roof at the other end and nail
in place.
Step 4:
Ensure Ridge Beam is straight, then nail the Clear Panel and Flat Roof Sheet (or second Clear Panel) to
45x45mm Bevelled Edge Supports using one 30mm Clout per Pan. Run two generous beads of Silicone on the
under side of the Pressed Capping Sheet. Position Pressed Capping Sheet on Ridge Beam and nail in place us-
ing three 40mm Weatherseals. Nail one 40mm Weatherseal into Ridge Beam beside each overlap (one nail per
sheet).
Step 5:
At the Back set up a String line in the centre of the Top Plate. Ensure Top Plate is straight and nail off, one 40mm
Weatherseal per Pan. Repeat at the front.
Note:
When nailing through the Clear Panel, pre-drill a 6mm hole.
11
TOP PLATE
JACK STUD
RIDGE BEAM
45 x 45 BEVEL
75mm NAIL
SILICONE
30mm CLOUT
PRESSED
WEATHERSEAL NAIL
PRESSED
CLEAR ROOF
FLAT ROOF
