10
KS1 DOOR JAMB & CORNER FLASHINGS
Step 2:
On the left hand side of the front wall fit Corner
Flashing (101) over Door Jamb Flashing and
rib . With top of the Corner Flashing flush with
the top of the Top Plate, rivet in place using six
rivets.
Step1:
Fit Door Jamb Flashing (104) in between Top
and Bottom Plates and hard against Stud.
Attach Door Jamb Flashing with three rivets
into Rib on the outside and three 30mm
clouts into studs on the inside. Repeat with
the other Door Jamb.
Step3:
Measure and cut Doorstep Flashing (106) to fit in
between Door Jambs. Position the Doorstep Flash-
ing in between the Door Jambs at bottom of door-
way, nail through top of flashing using three 30mm
Clouts. Repeat with the Overdoor Flashing (105).
Step 4:
Fit the two short front Corner Flashings over corner
Ribs and rivet in place using six rivets per flashing.
Fit the two longer back Corner Flashings over cor-
ner Ribs and rivet in place using six rivets ensuring
the flashing is flush with the top plate. When fitting
right hand Corner Flashing on the front wall, ensure
it is parallel with the Door Jamb.
DOOR JAMB
STUD
PLATE
CORNER
FLASHING
FRONT PLATE
CLADDING
END
