Duratech HAYBUSTER CMF-430, Инструкция по эксплуатации и перечень запасных частей

Страница: 28 / 108

18 C M F - 4 3 0 O P E R A T I N G I N S T R U C T I O N S
3.3 Hitching the CMF-430
Warning: Do not operate the CMF-430 unless the tractor complies with the following requirements:
•
Tractor has a minimum of 80 horsepower. (without two-speed option)
•
Tractor has rollover protective structure and seatbelts.
•
Tractor’s hydraulic system has at least (2) two-way valves, and a minimum
flow of 8 GPM @ 1500 psi.
•
To assure adequate braking and steering control while in transport, the tractor
must have a weight greater than or equal to 2/3 weight of the CMF-430 and any
mix it will transport at speeds more than 10 MPH. ((Max CMF 8,120 lbs. +
max load 9,000 lbs) x (0.67) =14,150 lbs.) ((Max CMF 3,683 Kg +
max load 4,082 Kg) x (0.67) =6,418 Kg)
•
1-3/8” 6-spline P.T.O. shaft
To hitch the CMF-430 to the tractor, perform the following steps:
1. Adjust the tractor drawbar so that the distance from the end of the P.T.O. shaft on the tractor to the center
of the drawbar hitch pin hole should be 16” (41 cm), and the height for the top of the centerline of the
P.T.O. should be 8” (20 cm). Refer to figure 3.6
2. Hitch the CMF-430 to the tractor drawbar. Adjust the hitch so the machine is parallel with the ground.
3. The hitch pin should be sized to prevent excessive movement, and should extend through all components
of the hitch. The pin should be secured with a hairpin clip or suitable device to prevent the loss of the pin.
4. Raise the jack. Pull the lock pin and store in transport position.
5. Attach the P.T.O. shaft to the tractor P.T.O. shaft. Depress coupling and slide the coupling onto the
splined shaft. Make sure the spring loaded safety catch is properly seated.
figure 3.6
Safe P.T.O. distance