1.
Loose the screws on the control connector
which holding the rod into place.
1
. Slide the battery into the battery hatch
with the power supply cable toward the
rear end of the plane and secure it using
the pre installed hook and loop tape.
Note
: You may need to relocate the battery
position to achieve the correct CG for
your model.
2
. Snap the clevis into the elevator surface
control horn.
1
. Make sure all the control sticks on
your radio are in the neutral position(rudder,
elevator, ailerons) and the throttle in the
OFF position.
move the elevator and
the rudder on the transmitter to make sure
aircraft control surface move correctly. If
controls respond in the opposite direction,
reverse the direction for operation of flight
controls.
Turn on the transmitter and
power on the model,
3
. The provided piece of fuel tubing keeps
the clevis closed during flight. Secure all
the linkages the same way.
Note:
Do not over slide the securing
tube or it will impede the movement
of the surface control horn. Install all
of the linkages the same way.
4
. Repeat the step
2&3
for the all the other
linkage hooking.
Test the electric device
Install the receiver
Hook on the linkage rod of the stabilizer
Test the stabilizer control servos
1
1
3
2
P.8
Содержание SUPERMARINE SPITFIRE MK24 V2
Страница 1: ...INSTRUCTION MANUAL ...
