Durafly SUPERMARINE SPITFIRE MK24 V2, Инструкция по эксплуатации

Страница: 10 / 26

2. Disconnect the battery from the ESC
after the binding process completed. Turn
off the transmitter and remove the bind
plug as necessary. Plug the elevator and
the rudder servos to the receiver.
1. Remove the battery hatch cover by rising
the band on the rear end of the cover, the
cover is attached into place by four pieces
of magnets on the rear and the foam nose
in front.
1.
with your transmitter. Please refer to your
Transmitter Manual for proper operation.
CAUTION : To prevent personal injury,
DO NOT install the propeller assembly
onto the motor shaft while binding the
receiver to your transmitter and in all the
testing steps until the manual tell you to
do it .
Before getting started, bind your receiver
4.
Attach the receiver to the receiver chamber
at the end of the battery hatch using double
side tape or velcro tape
3.
Note: All servo and retract leads have
been specifically labeled for your convenience.
Use the provided Y-harness for situations
where two or three servos are controlled by
one channel; for example ailerons, landing
gear, and flaps. Refer to the diagram bellow
for recommended connections.
Receiver connection diagram.
Receiver Y-harness
Aileron
Aileron
Channel-1
Aile
Elevator
Channel-2
Ele
Throttle
Channel-3
Thro
Rudder
Steering
Channel-4
Rudd
Landing Gear
Landing Gear
Channel-5
Gear
Flap
LED
Flap
LED
Channel-6
Aux1
Bind the receiver to the transmitter
Install the receiver
1
2
4
Test the electric device
P.7