Duracell Inverter 3000, Руководство по установке

Страница: 31 / 37

2–14 975-0445-01-01
This guide for use by qualified installers only
5. Locate the terminal wires which are all terminated with a vinyl
insulated butt splice connector.
The output wires are colored white for (N)eutral, black for (L)ine, and
green (or bare) for (G)round.
6. Run the AC output cable through the knockout, and through an
appropriate strain-relief device.
7. Insert the ground (bare or green) wire into the butt splice connector
for the ground terminal.
8. Insert the Line (black) and Neutral (white) wires into the butt splice
connector for Line and butt splice connector for Neutral terminals,
respectively.
9. Secure and permanently attach each of the wires (L, N, and G) using a
butt splice connector crimping tool.
NOTE: Once the wires are crimped and secured, they cannot be
detached without cutting the wires, thus, you can only make these
connections one time.
10. Complete the installation of the strain-relief device.
11. Replace the Inverter 3000 AC panel and secure the panel into place
using the screws from step #4.
12. Connect the outgoing AC wires to the AC load panel.
WARNING: Shock hazard
Exposed and uncapped wires are a shock hazard. If you cut the wires after
permanently connecting the AC output wires make sure that you terminate the
wires with a proper wire cap terminal.
Inverter_3000_Install_Guide.book Page 14 Tuesday, June 3, 2008 12:22 PM