Duplo DF-1000, Инструкция по эксплуатации

Страница: 61 / 86

4-11
5
After adjusting folding misalignment,
press the adjustment registration key
until the buzzer sounds “pi.pi...”.
When adjustment registration completes, the
lamp of the folding mode selected stops lighting
and starts to blink.
1. CORRECTING FOLDING MISALIGNMENT
<Changing/erasing adjustment registration data>
1) Set the paper size whose adjustment registration data is to be changed or erased.
The paper need not be actually stacked on the paper feed tray, just move the side guides to this paper size
using the side guide dial.
2) Use the folding mode key to select the folding mode whose adjustment registration data is to be changed or
erased.
3) To change the registered data, perform steps 3 to 5 of the above registration procedure. The data will be
rewritten.
To erase the data, proceed to step 4) .
4) Press the adjustment registration key until the
buzzer sounds “pi.pi...” (press for about two
seconds), and then continue pressing for another
two seconds until the buzzer sounds “pi...”. (Total
four seconds)
When the registered data is erased, the selected
folding mode lamp stops blinking and lights up,
and the adjustment value displayed on the LCD
changes to “0.0/0.0”.
B4 0.0/ 0.0
STAND BY
Blinking (End of adjustment registration)
Lit (When adjustment registration is erased)