3-2
Paper that is not A3, B4, A4, B5, A5, or B6 are considered non-standard paper. Standard
paper that is fed in the long edge feeding direction is also considered as non-standard paper.
When using non-standard paper, the length must be entered and registered before beginning
folding operation.
1. STANDARD FOLDING OF NON-STANDARD PAPER
1-2. Operation Procedure
1
Measure the length of the paper to be used.
The length is the side parallel to the paper feed direction (see
top figure
).
Starting operations without registering the paper length will display the error message
“INPUT LENGTH” on the LCD.
1-1. Paper Size Restrictions
Paper sizes which can be used are the sizes
within the range shown on the right.
Paper feed direction
Paper
Length: 182 to 432 mm
Width: 120 to 297 mm
2
Turn on the power switch.
3
Stack paper on the paper feed tray.
4
Move the side guides according to the paper width.
5
Set the rear guide at the trail edge of the paper.
For details of steps 2 to 5, refer to “1-3. Operation Procedure” in Chapter 2 BASIC
OPERATION “1. STANDARD FOLDING OF STANDARD PAPER” (
p.2-3).
To insure the quality of the fold
when paper width is 120 mm, it is
recommend not to exceed 240 mm in
length.
Содержание DF-1000
