Dunlop L.MAS.MOV.C.M, Руководство по установке

Страница: 9 / 20

L.MAS.MOV.C.M
Nissan Interstar Opel Movano Renault Mastervan
9
DUNLOP and the Flying D Device are trademarks of Dunlop International Group and are used under license by DSC Nederland B.V.
www.dunlopsystems.nl
5.5 Bellow Installation
i. See Section 5.6 - “Tube Connection and Disconnection, Cutting and
Routing” : Connect a tube to the bellow by pushing the tube into the
air inlet port on the underside of the spring and then hand-rotating
the tube by one screw turn. Use black tubing for the left-hand
bellow and blue for the right-hand bellow. Feed the tube through
the large exposed hole in the upper bracket—Figure 8.
ii. Place the bellow into position between the upper and lower brackets
and attach the lower plate of the bellow to the lower bracket using
two M8 x 16mm bolts and two washers—Figures 8 and 9
iii. Attach the top plate to the top plate of the bellow using a single M8
x 20mm bolt and a single M8 serrated washer—Figures 10 and 11
5.4 Fitting of Lower Bracket
i. Rest the lower bracket on the axle directly below the upper plate,
with the two ‘feet’ placed beneath the leaf spring mounting block—
Figure 6
ii. Insert the two M10 x 100mm countersunk bolts into the countersunk
holes in the lower bracket, feed the lower bracket strap up from
below the axle to mate with these bolts, and install the nuts and
washers to secure the lower bracket and strap against the axle—
Figures 6 and 7
iii. After connecting it to each other again on the mall bracket. It is
needed to bleed the brake line at the left side.