Dunlop L.MAS.MOV.C.M, Руководство по установке

Страница: 12 / 20

L.MAS.MOV.C.M
Nissan Interstar Opel Movano Renault Mastervan
12
DUNLOP and the Flying D Device are trademarks of Dunlop International Group and are used under license by DSC Nederland B.V.
www.dunlopsystems.nl
Cutting
To achieve good sealing and air-tight fitting of tube ends to their
connecting parts, it is very important to cut tubing cleanly and squarely.
A dedicated guillotine action tubing cutter is recommended, or a craft
knife if such a tool is not available. Do not use electrician’s side cutters.
A dedicated tubing cutter -
Recommended
Electrician’s Side Cutters
NOT Recommended
Connection and Disconnection
Tubes are connected as shown by the diagrams below...
5.7 Tube Connection and Disconnection, Cutting and Routing
A B C
A. Slide a nut over the end of the tube
B. Push the tube onto the connector as far as possible
C. Feed the nut up to the connector, fully tighten by hand and finally
tighten one additional turn using spanners