El
ec
tr
ic
H
ea
te
r I
ns
ta
lla
ti
on
(
O
pt
io
n)
Measure the proper distances for the heater template according to the heater manufacturers instructions.
Using the template provided, drill four 9/64" holes to fasten the heater to the wall.
Install the two longer hex head lag screws (supplied with the heater) into the upper two holes.
Hang the heater on the two upper screws.
Install the two shorter hex head lag screws (supplied with the heater) into the two lower mounting holes.
Ensure the heater is level and then tighten all 4 hex head lag screws to lock the heater in place.
The following installation instructions are for the Helo Cup (Saaku) electric heater.
Always refer to the original sauna heater manual for confirmation.
Read all instructions carefully.
ph: 519-923-9813 | [email protected]| web: www.dundalkleisurecraft.com
30
Dundalk LeisureCraft
Panoramic Barrel Sauna Assembly Instructions
Rinse the rocks with water before placing in the heater.
Carefully place the rocks loosely so that the air can circulate through the heater.
Packing the rocks too tightly may cause the heater high limit switch to trip.
The rocks must fully cover the heating elements.
•
Operate the heater for an hour with the sauna door fully open to burn off any residual coating from the
manufacturing process before using.
*The wiring for the electric heater most times enters the sauna underneath the heater as shown above.
* All wiring should be installed according to the heater manufacturers instructions and by a licensed
electrician.
•
Do NOT use a G.F.I breaker
