Ve
nt
K
it
(
O
pt
io
n)
ph: 519-923-9813 | [email protected]| web: www.dundalkleisurecraft.com
Dundalk LeisureCraft
Panoramic Barrel Sauna
Vent Kit Assembly Instructions
42
Drill inlet holes centered underneath the heater.
Fig.1
* A 2” diameter hole saw was used for these
pictures but more holes with a smaller drill size
will also work.
Install 1 of the stainless steel vent grills over the
inlet holes on the outside of the sauna centered
over the holes using 1 ½” screws. (6pcs)
Fig. 2
Fig.2
On the middle stave, close to the dome, drill the
outlet holes in the same manner as the previous
step.
Fig.3
(Ensure you are on the inside of the aluminum
band before drilling)
Fig.4
Install the other Stainless Vent cover over the
outlet holes on the outside using 1-1/2” stainless
steel screws. (6pcs)
*To prevent water from entering sauna when it
rains, Do not place holes any higher than the
middle stave.
Fig.4
Fig.1
Fig.3
Fig.5
Install the cedar vent cover over the outlet holes
on the inside of the sauna with a 1 ½” screw.
Fig.5
* Tighten screw enough that the vent cover
still rotates smoothly. Fig.6
Fig.6
