Duke FBB-NC-120, Инструкция по установке и эксплуатации

Страница: 10 / 36

Installation and Operation of Flexible Batch Broiler
10
Setup
Install all items as shown below.
Loader Install Tool
(Included with Broiler Tools Kit)
Install loader bracket with (4) 1/4-20 nuts.
Use supplied extension tool to remove and reinstall nuts.
(Nuts are shipped installed on loader mounting studs.)
D. ADJUSTMENTS AT INSTALLATION
Each broiler section and all its component parts have
been tested thoroughly and inspected before your broiler
was shipped from the factory. However, it is sometimes
necessary to further test or adjust the broiler once it has
been installed. Such adjustments are the responsibility
of the Dealer or Installer. These types of adjustments
are not considered defects, rather a normal and routine
part of the proper installation of the equipment.
These adjustments include but are not limited to:
• Adjustments to the gas pressure regulator
• Broiler height adjustment (if required)
No installation should be considered complete without
proper inspection and, if necessary, any adjustments
by qualified service or installation personnel.
It is also important not to obstruct the natural flow of
combustion and ventilation air if the broiler is to operate
properly. This broiler should not be installed on a
curb base or sealed to the wall. Either condition can
restrict the flow of air to the combustion compartment
or prevent proper ventilation of the unit. Before making
any connections to the broiler, check the ratings plate to
be sure the broiler specifications concur with the type
of gas and voltage to be supplied to the broiler.
The rating plate is located on the back of the control
compartment cover panel on the right end of the unit.
The plate bearing the broiler’s model number and serial
number is attached to the back side of the unit.