3
SETUP
1. RECEIVER
Screw on the long antenna ( see 10 below). The receiver audio output (6 below) is via a
3.5 mm mini plug on the front of the unit . Connect this output to an amplifier or the MIC
input of a projector.
The audio out is at line level, so if connecting to a
Dukane projector
set the MIC
LEVEL to HIGH. This is found on the projector at ADVANCED MENU then AUDIO /
MIC LEVEL / then HIGH. For the projector set the volume to about mid-range.
The receiver is powered by a DC voltage from a power adaptor (5V ,500mA) which is
next plugged into a 115 VAC power line outlet. The adapter connector is plugged into the rear of the re-
ceiver, (see 13 below).
Next turn the power switch to ON (12 below) on and switch (11 below) to “20 dB / mic” you will see green
LED light
“Status” (3 below) begin
flashing.
The
NUMERIC LED display
(5 below
)
may light up with the “01” . This display shows the Channel number
or the Volume level of the receiver. For initial setup the volume can be set to about mid range at 17 ( Vol
Range is 0 to 31) . The Ch (Channel) can be set to avoid another know system channel ( channel range is 1
to 80). For initial operation any channel may work.
Note the green “Status” LED ( 3 below ) on the receiver continues flashing.
Set switch to 20dB / MIC
Blank ; Receiver front
Audio output
Power switch ; set to ON
Power Input jack
Audio Output jack 3.5 mm mini
Green LED—Status indicator
