2
Thank you for purchasing the Dukane Wireless Microphone System
WMIC1. This system operates using digital voice coding which is transmitted by radio frequency signal
at 2.4GHz.
The system consists of a small lightweight transmitter into which a headset, lapel or other mic can be
plugged. The transmitter unit has a lanyard or cord so it can be worn around the user’s neck.
The wireless radio frequency, RF, signal is sent to a receiver unit that can be placed somewhere in
the room. The receiver is typically near a audio amplifier. Or the receiver can be placed on or near a
projector which has a “mic input”. The projector can then amplify the signal for it’s internal speakers.
Inside the projector the signal can also be switched and mixed with other audio inputs. Furthermore
the projector can control the volume level and the signal can be obtained from the audio output for use
with external amplifiers and speakers.
The range for the mic transmitter is about 100 feet. The system can operate on any of 80 selectable
channel frequencies. The channel is set by the receiver and visible on the LED numeric display of the
receiver. The channels range is from 2.400 to 2.480 GHz starting with 2.401 and increasing in 0.001
steps to 2.480 GHz.
Upon initial operation the transmitter is paired to the preset receiver channel by bringing the mic trans-
mitter within about 6 ft. of the receiver. Once paired the system can operate at the full range. Due to
the many channels available, other identical mic systems paired to a different channel can operate in
close proximity.
The transmitter has a red LED to indicate low battery charge, and a green LED to indicate the “paired
to receiver” status. A flashing green LED on the transmitter or receiver means the system is “seeking a
device” for pairing.
Wireless mic WMIC1 User Guide
FCC Statement: DECLARATION OF CONFORMITY
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interfer-
ence received, including interference that may cause undesired operation.
Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or
more of the following measures:
Reorient or locate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Caution
: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
GENERAL INFORMATION
Your projector with speakers
Your amplifier with speakers
Wireless Mic and Receiver System
