Dukane iQ Auto-Plus 20AT060-U Series, Руководство пользователя

Страница: 34 / 71

Page 28
iQ Series
,
Auto-Plus User’s Manual
Dukane Manual Part No. 403-591-01
iQ
Auto-Plus System
Operational Test
1. Verify that the standard system installation is complete
and all cables are connected. If using an MPC module
verify that the MPC installation is also complete.
Refer to installation instructions included in Section 3,
if needed.
Refer to Section 6 - Automation Interface -for infor-
mation on wiring system controls, if needed.
2. After completing Step 1, activate line power to the
iQ
Auto-Plus system.
Normal Condition :
GREEN - The POWER and STATUS
LEDs
on the iQ
Auto-Plus panel should both light up GREEN.
The system is now ready to operate.
Troubleshooting Abnormal iQ Auto-Plus System
Conditions
POWER
LED
RED - If this
LED
lights up RED, check line
voltage level.
GRAY - If this
LED
is a gray color (not lit),
check line input.
Optional System Status Output to Monitor
:
Optionally the Any Fault Status Out status output
can be monitored on system I/O connector Pin 5.
This status output signal will activate when power
is not OK.
Optionally the READY output can be
monitored. This status output signal will
activate when the generator is ready to operate.
3. After completing Step 2, test ultrasound output by
activating system I/O connector Pin 13.
Normal Condition
:
The system is operating properly when power is
delivered to the attached stack.
Figure 4-1 Generator POWER LED De2tail
Ultrasound Activation Connections
:
Usually an automated control system is wired to
this control input.
Optionally - A manual switch could be wired to
this control input.
Options for U/S Activation Connections
:
Optionally, monitor the U/S Activate status output on
system I/O connector Pin 13.
This status output signal will activate when U/S is ON.
4. Other Options the Operator can Check:
•
Fault Status output signals
Fault Status output signals are available for:
Overload (Pin 3), or
Any Fault (Pin 5).
These status outputs will activate when there is a fault:
POWER LED
Continued