Dukane iQ Auto-Plus 20AT060-U Series, Руководство пользователя

Страница: 26 / 71

Page 20
iQ Series
,
Auto-Plus User’s Manual
Dukane Manual Part No. 403-591-01
Figure 3-3 MPC Interface Connector
Multi- Point Control (MPC)
Interface
The MPC Interface connector powers and controls an
external MPC module. This external module must be
purchased in addition to a basic generator for a fully
functional MPC system. It can be ordered with a minimum
of two probe controls and up to a maximum of 16 probe
controls.
MPC Interface Connector (J2)
Connections required for the external MPC module are
described below.
•
MPC I/O - MPC control/input signals and status out-
put signals are carried in the I/O cable that should al-
ready be connected. See Table 3-II on Page 21 for
further information.
•
MPC INTERFACE - Attach one end of the MPC Inter-
face cable (Dukane # 200-1408-XX) to the MPC con-
nector on the iQ generator panel in Figure 4-2. Connect
the other end of the cable to the MPC INTERFACE
connector on the right rear of the MPC module.
NOTE
The MPC Interface cable is a separate
line item on the iQ generator system
order. The -XX at the end of the cable
number specifies cable length. This will
vary depending on your MPC installation.
MPC INTERFACE CONNECTOR
NOTE
This information is for the MPC/MPCQ
models only. If connecting to a MPC-E
models, see document 403-617 MPC-E
Multi-Point Controller Quick Start Guide.
Refer to Dukane’s website for more information about
the MPC-E Quick Start Guide at the link below:
https://documents .dukane .com/Manuals/403-617 .pdf