20
Operating
1.
Turning off
2.
Press the STANDBY/ON
STANDBY/ON button again while the
message is shown.
The projector lamp will go off, and the POWER
POWER
indicator will begin blinking in orange.
Then the POWER
POWER indicator will stop blinking
and light in steady orange when lamp cooling is
complete.
3.
After making sure that the POWER
POWER indicator lights in steady orange, and
press down the side marled “O
O” on the power switch.
The POWER
POWER indicator will go off.
• Use the shutdown switch only when the projector can be not turned
off by normal procedure.
NOTE
►
Do not approach the lamp cover and the exhaust vents for a
while after the lamp goes out, since they may be hot and could cause burns.
WARNING
►
Turn your device off prior to the projector, except for the cases
directed by the manuals of devices.
NOTICE
The following walks you through the steps to turn the projector off.
For other devices, follow the manual of each.
Press the STANDBY/ON
STANDBY/ON button on the projector
or the remote control.
The message "Power off?" will appear on the
screen for about 5 seconds.
STANDBY/ON
SHUTTER SECURITY LAMP TEMP POWER
STANDBY/ON
Using the elevator feet
Lengthening or shortening the length of the elevator feet shifts the projection
position and the projection angle.
Turn the elevator feet each to adjust their length
►
Do not place the projector with an inclination of 5 degrees
or more. The projector leaned exceeding the limit could cause malfunction and
shorten the life of the projector .
CAUTION
5°
►
Do not lengthen the elevator feet to 30 mm or more. The foot
lengthened exceeding the limit may come off and drop the projector down, and
result in an injury or damaging the projector.
WARNING
max.
30 mm
Power
switch
POWER
POWER indicator
STANDBY/ON
STANDBY/ON button
