17. Tandem flying
ZeroGravity harness was not designed - and remains unsuitable - for tandem operations.
18. Cleaning and storage
All materials for the harness have been carefully selected, keeping their quality and durability in mind. Your care and maintenance of
the harness will keep in good condition for a long time. The harness is best cleaned with a wet sponge, possibly a bit of soap. Do not
use neither detergents nor solvents. If there is a lot of mud, use the brush first before wet cleaning.
In case of completely soaked harness (e.g. after waterlanding) dry it in a well aired place, away from direct sun operation.
Soaked back protector must be taken out of the harness and dried with its zip opened. If this will be not enough, remove the airfoam
and dry it separately.
Soaked rescue chute always has to be completely removed from the harness, dried and packed again by a licensed person.
Harness can be stored in a backpack, but if you want to give it best service – keep it de-rigged in a well-ventilated place, away of
sunlight. If the harness is not going to be used for a longer time, it is advised to get it out of the backpack. Unfortunately some
discoloration of the harness’ parts is unavoidable over time and this is yet another reason for not exposing it to the sun more than
necessary.
Before packing the harness remove the stiffener from the upper area of the back pocket. Open the cockpit and put the instrument
panel inside for protection.
45
Содержание ZEROGRAVITY
