16
15. ACCESSoRIES
15.1
Flashing Light SW7500 - FLASH
Connect the flashing light with 12V max 10W bulb to the circuit board circuit diagram of FIG.16 for versions with
card CTH43 and FIG.17/A for versions with CTH46 card.
The flashing light must be positioned so as to make visible and to alert people on the presence of an automation
system operating.
During the opening cycle, the flashing light flashes slowly.
During the closing cycle the flashing light flashes quickly.
The flashing light can be horizontally or vertically wall mounted using the supplied brackets. see FIG.22/23
1 - open the cover of flash light
2 - unscrew the two screws that are located inside
3 - disconnect the bottom
4 - decide the fixing position of the flashing light. Drill the wall in correspondence of the fixing holes
5 - predispose the cable passage
6 - attach the flashing with screws and dowels
7 - screw the bulb (12v 10W max) and replace the cover
It is advisable to seal the outlet passage of the cables with silicone.
15.2
EXTERnAL AnTEnnA 6025 or 6023 Mhz 433.92
Each automated system is equipped with built-in antenna on board. If necessary, you can connect an external
antenna.
Warning:
it is not recommended for use in areas with frequent thunderstorms as an antenna system is more
vulnerable to electrostatic discharge that can irreversibly damage the circuit board. This event will be considered
out of warranty.
Model 6025 can be installed directly on Flashing light SW7500-FLASH see FIG.24.
Model 6025 is equipped with universal fixing bracket.
See electrical connections: FIG.16 for versions with electonic board CTH43
and FIG.17/A or versions with electonic board CTH46
15.3
Key switch SW5000-KEY5000
The key switch is a wired device that allows you to operate your door.
The contact is NO. Turnthe key to activate the command.
Connect the key switch to the circuit board circuit diagram of FIG.16 for versions with card CTH43 and FIG.17 /
A for versions with CTH46 card.
The selector must be fixed to the wall and is suitable for outdoor use.
It is advisable to seal the outlet passage of the cables with silicone. see PICT.21-22
Use the same procedure to connect the key switch is also possible to connect other devices such as cable or
intercom or buttons
15.4
Photocells ( safety beam) SW 7120-7012; LASER 7120- 7012
The photocells are an optional accessory.
A set includes 1 photocell transmitter (RX) and 1 photocell receiver (TX)
The interruption of the infrared beam produces the re-opening of the gate.
In case of use on a solar panel powered system we recommend the use of the specific model with low
consumption SW7120.
According to the latest European standards in the field of impact forces: EN13241 - 1 : 2003 + A1 ( April 2011),
EN 12453 : 2000 EN 12445 : 2000, safety should be secured by the same automation, regardless of optional
accessories such as photocells.
The legislation provides that automation can not exert a pressure higher than the limits defined by the law and
and in case of impact must detect the presence of the obstacle and must remove the pressure exerted on the
obstacle within a precise time curve. (see Norm text for more specifications).
The photocells are not therefore more mandatory since their effectiveness is limited.
The photocells are useful in order to control the reopening of the gate while the same is closing.
This prevents, for example, that the paint of vehicles may be ruined if the gate closes while a vehicle crosses