Ducati DCS4200, Руководство пользователя

Страница: 36 / 52

Owner’s manual
DSC4200
CHAIN SA
W
English
36
(2) Fuel
(3) Switch
(4) Primer bulb
(5) Throttle lever
(6) Throttle interlock
(7) Choke knob
4. Pull out the choke knob to the closed
position.
7
pull
NOTE
When restarting immediately after stopping
the engine, leave the choke knob at the open
position.
5. While holding the saw unit securely on the
ground, pull the starter rope vigorously.
WARNING Do not start the engine while
hanging the chain saw with a hand. The
saw chain may touch your body. It’s very
dangerous.
6. When engine has ignited first, push in the
choke knob and pull the starter again to
start the engine.
7. Allow the engine to warm up with the
throttle lever pulled slightly. Keep clear of
the saw chain as it will start rotating upon
starting of engine.
Checking oil supply
After starting the engine, run the chain at
medium speed and see if chain oil is scattered
off as shown in the figure.
7. OPERATING ENGINE
Starting engine
1. Fill fuel and chain oil tanks respectively, and
tighten the caps securely.
2
1
2. Put the switch to “I” (RUN) position. (F8)
3
RUN
3. While holding the throttle lever together with
the throttle interlock. Push in the primer bulb
to have fuel and release the throttle lever to
hold it at the starting position.
6
3
4
(1) Chain oil