6.
Operation
NOTE: The control panel may be look like one of the followings:
Swing button
Used to initiate the Auto swing feature. When the operation is ON, press the
SWING button can stop the louver at the desired angle.
Timer button
Used to initiate the AUTO ON start time and AUTO OFF stop time program, in
conjuction with the + & - buttons. The timer on/off indicator light illuminates under
the timer on/off settings.
Mode button
Selects the appropriate operating mode. Each time you press the button, a mode
is selected in a sequence that goes from AUTO), COOL, DRY, HEAT (cooling
only models without)and FAN.
The mode indicator light illuminates under the different mode settings.
Up (+) and Down (-) buttons
Used to adjust (increasing/decreasing) temperature settings in 1°C increments in
a range of 16°C to 32°C or the TIMER setting in a range of 0~24hrs.
Speed
Control the fan speed. Press to select the fan speed in four steps-LOW, MED,
HIGH and FAN(AUTO). The fan speed indicator light illuminates under different
fan settings. When select AUTO fan speed, all the fan indicator lights turn dark.
Sleep button
Used to initiate the SLEEP operation.
Power button
Power switch on/off.
LED display
Shows the set temperature in °C and the Auto-timer settings. While on DRY and
FAN modes, it shows the
“--”.
Shows Error codes and protection code:
-
E1 - Error with outdoor coil sensor (excluding single cooled models).
- E2-Indoor temperature sensor error.
-
E3-Indoor tube temperature sensor error.
-
E4-Display panel communication error.
81
