DAILY OPERATION
Check the power cord to insure that it is plugged into a proper outlet.
Set the heat control knobs to desired temperature.
Always allow 10 minutes of preheat time before loading the unit with product. Failure to allow
sufficient preheat time will result in unsatisfactory cooking until the unit reaches operating
temperature.
OPERATING HINTS AND SAFETY
Disconnect power to the unit with the switch at the end of each day of operation.
Do not leave the unit in operation without an attendant.
Turn Power Saver Switch to Standby during idle periods. It will take only a few minutes to
regain operating temperature.
Do not leave the unit at high temperature when not in use or during idle periods. This will
cause food particles and grease film to carbonize.
CLEANING
Preventive maintenance for your Dualit toaster consists of the following recommended
cleaning procedures. To keep your toaster in its top operating condition, these steps should be
performed on a daily or weekly as indicated.
A.
Clean air intake on bottom of unit.
B.
For lightly soiled conveyor belts, turn conveyor speed control to fastest setting (100) and
wipe with a damp cloth (daily) For heavily soiled conveyors, turn conveyor speed control to
fastest setting and wipe with a light abrasive pad (as needed).
C.
Turn main power saver switch to the OFF position. Disconnect unit from power source.
D.
After the unit cools, remove interior crumb tray (as shown below) and clean. Slide crumb `
tray back into position.
E.
Wipe exterior surface of unit.
WARNING
DO NOT IMMERSE OR LET THE UNIT STAND IN WATER.
DO NOT HOSE DOWN THE UNIT OR THE TABLE/COUNTER IF THE UNIT IS ON
THE TABLE/COUNTER.
KEEP AWAY FROM RUNNING WATER.
CLEAN
OPERATE
CRUMB TRAY REMOVAL
