9
Warning
!
10. Troubleshooting
• Before doing any jobs, perform the operations described in the “Stopping the
Pump” paragraph. In the event of not being able to restore the correct operation of
the motor pump with the aid of the information contained on the “Washer & Pump
Troubleshooting” table, contact a Skilled Technician.
General Engine Troubleshooting
Refer to manufacturer’s manual for full engine troubleshooting information.
Problem
Possible Cause
Remedy
Engine will not start
Engine switch in OFF position Switch to ON position
No or low oil level in engine
Fill engine crankcase to required
level
No or low fuel level
Fill fuel tank
Stale or contaminated fuel
Drain fuel tank and replace with
fresh fuel
Bad spark
Check HT lead or replace spark
plug
Over-choking
Open choke and crank engine over
Engine falters or not
running smoothly
Choke is opened too soon
Close choke until engine runs
smoothly
Engine shuts down
during operation
Out of fuel
Fill fuel tank
No or low oil level in engine
Fill engine crankcase to required
level
Engine lacks power
Throttle not fully open
Open throttle
Dirty air filter
Replace air filter
9. Storage Information
The Washer & accessories should be stored in a dry and frost proof location. Frost can
lead to serious component damage which is not covered by warranty.
Disconnect all hoses, lances & accessories and drain water.
Crank the engine over using the recoil start to expel water from pump.
Ensure all equipment is clean and dry.
When storing unit for extended periods of time add a fuel stabiliser to the fuel or drain
the fuel from the tank. Refer to engine manufacturer’s manual for information on how to
prepare the engine for storage
