Du Pont WFQTR13000 Series, Руководство по установке

Страница: 4 / 16

WFQTR130004
4
V4.1C
4
STEP 2
Mount the System Head
NOTE: Filter should be 3 feet or less from the appliance.
1
Choose an easy-to-access area behind the refrigerator.
NOTE: To allow adequate space for filter changes, allow a minimum clearance of 4-6” below the QuickTwist ® Filter. The Filter System
must be mounted in a vertical position.
2
Remove the cap from the top of the System Head
A
. Using the Built-in Bracket on the back of the System Head mark the holes for
the Mounting Screws
C
on the wall surface. Filter Head should be mounted to a firm surface.
3
Use a 1/8” drill bit to bore pilot holes into marked hole positions or drive screws directly into the marked positions. This may require
the use of toggle bolts to hold in dry wall.
4
Hang the System Head on the eyes of the bracket and replace the System Head cap.
STEP 3
Locate Water Line & Cut
1
Select the desired spot to install the filter. Cut the cold water line cleanly. Some water will likely leak from the line. Make sure
that the cut is square and free from any internal or external burrs.
STEP 4
Cutting or Disconnecting the Refrigerator
1
Determine the length of 1/4” Plastic Tubing that will be necessary to connect the System Head Outlet to the refrigerator.
Make sure to allow enough Plastic Tubing to prevent kinking in the line and that you can pull the refrigerator out from the wall 6’ - 8’.
2
Cut the 1/4” Plastic Tubing squarely on both ends, making sure not to crimp the Plastic Tubing during cutting.
3
Wet one end of the 1/4” Plastic Tubing with water and push it into the System Head Outlet until it stops.
4
Carefully create loose coils (3 or 4) to take up the slack on the plastic tubing between the filter head and refrigerator.
This will prevent crimping.
NOTE: Do not bend or crimp 1/4” Plastic Tubing when inserting.
5
Connect water line to inlet part on System Head.
3
DO NOT screw system head directly to
refrigerator.
CAUTION
Water supply to the refrigerator should have a separate shut off valve installed before the filter.
If it does not have a separate shut off valve one should be installed.
NOTICE
X
X
2
FOR FLEXIBLE PIPE WATER LINES
TUBING
NUT
SLEEVE
THREAD
MALE
PIPE
THREAD
FOR COPPER OR METAL WATER LINES
*Note: This hardware is not included. Visit your local hardware store
for these brass compression fittings or call customer service
`
Front View
Side View
To Refrigerator +
4