Du Pont Cyrel FAST 2000TD, Руководство по эксплуатации

Страница: 26 / 106

2-8
Operation procedures
Plate width (2):
Enter the width of the plate.
Allowed values: min. 600 mm (23.6") - max. 1067
mm (42.0").
2 selection options are possible:
- enter the width into the dialogue box using
the pop-up input keypad, or
- select one of the 2 blue shortcut buttons
for the 2 most commonly used plate
widths.
The display shows values in either metric
(millimeters) or imperial (inches) units depending
on the selection made in the 'General settings'
(editable by daily operator). See also description of
"General settings" on page 3-12.
Plate gauge (3):
Enter the thickness/gauge of the plate.
Plate gauge is shown in imperial units (thousands
of an inch).
A drop-down menu will display the available plate
gauges.
Available plate gauges are set in the configuration
(service personnel only).
If an invalid value is chosen, you'll be prompted
with this yellow note.
At the same time the field (6) (see description
below) displays "NoValidJobSetup".
This means that none of the pre-programmed plate
types match the chosen plate gauge value.
Either chose new plate gauge value or change the
plate type.
NW type (4):
Enter the nonwoven material type used from the
drop down list. There will be one or more options
available.
Operation Manual | Cyrel FAST 2000TD January, 2020