54
9. Adapting to Derivative Microcomputers
Modifying Parameters
9.1. Minor Parameter Modification through the Keyboard of NET IMPRESS
For the parameters that are defined by the function commands (FUNCTION D1 to FUNCTION
DF) as described in the Section 5.4 “Parameters Settings” of the NETIMPRESS next Instruction
Manual, you can modify them through the keyboard of NETIMPRESS.
Parameters for communication interface with the target system, voltage of the target system,
etc., for example, are the ones you can modify through the keyboard of NETIMPRESS.
Note:
You cannot modify wide-ranging parameters and settings of the target microcomputer such as
ROM block configuration (FUNCTION D6) through the keyboard of NETIMPRESS. (Use the
remote controller AZ490.)
Also, the parameter list of actual microcomputers is available at our Web site in some cases.
For more information, contact us or your local distributor.
9.2. Modifying Parameters for Target Microcomputer using the Remote Controller
We provide the remote controller software (AZ490) for controlling NETIMPRESS remotely from
a PC. The remote controller can be downloaded from our home page. This remote controller has
the function to set up and confirm parameters besides the remote control capability.
With the remote controller, you can set up and modify parameters including the following.
(1) MCU Type:
Name of a target microcomputer
The name of a microcomputer displayed on the LCD of NETIMPRESS
can be customized.
(2) Flash ROM Area:
Flash memory area of a target microcomputer
(3) ROM Block:
Flash memory block alignment can be set up with address and size for
each ROM group, enabling you to use the Control Module with
derivative microcomputers.
(4) MCU Clock:
MCU clock frequency can be set up.
(5) Communication Interface: A communication interface with a target system can be setup.
(6) Other:
Microcomputer-specific information
