Chapter 5
38
If you do not wish to save the old BIOS:
5.
Please type “N”, and then press the ENTER key.
6.
Then you will be request to answer:
“Are You Sure to Program?”
7.
Answer “N” if you do not want to program, and then it will exit.
To save the old BIOS:
8.
Please respond “Y”, and then press the ENTER key.
9.
Move the cursor to “File Name to Save:”
10.
Type file name “2A59F000.OLD”, and then press the ENTER.
(Your old BIOS will be saved in the file name you create. In this case, the
old BIOS is saved in the file name, 2A59F000.OLD).
11.
Then you will be requested to answer:
“Are You Sure to Program (Y/N)?”
12.
Type “Y” to begin programming, and press the ENTER key.
13.
When the programming is finished, the showing message will appear:
“Programming Flash Memory - 1FF00 0K
Message: Please Power off or Reset System”
14.
Once you see the showing message “Power Off or Reset System”, please re-
start your system.
15.
When you power on the computer again, you will find your old BIOS has
already been successfully updated.
Warning
Please note that Award Flash Utility cannot run under EMM386 or QEMM. Thus,
when executing the command “awdflash”, and error message will appear:
“Error Message: Fail - Due to EMM386 or QEMM!”
Содержание PRM-0081I E1
