DTK PAM-0057V, Руководство пользователя

Страница: 27 / 58

Connector Configuration
21
3.3 J10, J11 - PRIMARY/SECONDARY IDE
CONNECTORS
J10 is the Primary IDE connector, and J11 is the Secondary IDE connector. These
connectors support the provided IDE hard disk ribbon cable. After connecting the
single end to the board, connect the two plugs on the other end to the IDE device, such
as hard disk.
3.4 J12 - FLOPPY DRIVE CONTROLLER
This connector supports the floppy drive ribbon cable. After connecting the single end
to the board, connect the two plugs on the other end to the floppy drive.
3.5 J13 - PARALLEL PORT CONNECTOR
This connector supports for the printer port ribbon cable. After connecting the single
end to the board, connect the external parallel interface device to the D-Type 25-pin
female connector on the other side.
3.6 J14, J15 - SERIAL PORT 1 AND 2
J14 is the UART1 interface for COM1 and J15 is the UART2 interface for COM2.
These connectors support the provided serial port ribbon cable for connecting the
external serial devices.
3.7 J16, J17 - UNIVERSAL SERIAL BUS PORTS 0 & 1
J16 is defined as USB0 and J17 is defined as USB1. These connectors support the
optional USB cable for connecting the external USB device.
Fig. 11 USB0 & 1 Connector