DTK PAM-0057V, Руководство пользователя

Страница: 42 / 58

Chapter 4
36
IDE Primary Master PIO/IDE Primary Slave PIO/IDE Secondary Master PIO/IDE
Secondary Slave PIO:
Available selection are “Auto”, “Mode 0”, “Mode 1”, “Mode 2”, “Mode
3” and “Mode 4”. To choose “Auto”, the system BIOS will scan the IDE device and decide
which mode of the device is . Otherwise the user should key in the mode of the device to the
corresponding field.
Some harddisks cannot work properly with its corresponding timing, please set a slower
timing.
Primary Master Ultra DMA/Primary Slave Ultra DMA/Secondary Master Ultra
DMA/Secondary Slave Ultra DMA:
Available selection are “Auto” or “Disabled”. To choose
“Auto”, the system BIOS will scan the IDE device and decide Ultra DMA supported or not.
Onboard FDD Controller: Choose Enabled or Disabled. “Enabled” allows onboard Floppy
Drive Controller to be functioned, otherwise the users should use other sources..
Onboard Serial Port 1: Choose None, Auto or from COM1, COM3, COM4 with different I/O
Address. While choosing proper I/O Address, be sure not to cause Address conflict with other
I/O devices.
Onboard Serial Port 2: Choose None, Auto or from COM1, COM2, COM3, COM4 with
different I/O Address. While choosing proper I/O Address, be sure not to cause Address conflict
with other I/O device.
UART 2 Mode: Choose Standard, ASKIR and HPSIR for IrDA serial Interface.
IR Function Duplex: This item will be shown only when UART 2 Mode is selected to ASKIR
or HPSIR. The available options are “Full” and “Half”. It is used to choose the IR function
working in full duplex mode or half duplex mode correspondingly.
RxD, TxD Active: This item will be shown only when UART 2 Mode is selected to ASKIR or
HPSIR. The available options are “Hi, Hi”, “Hi, Lo”, “Lo, Hi” and “Lo, Lo”. It is used to
configure the logic level of Receive and Transmit signal in IrDA interface.
Onboard Parallel Port: Choose None or with four different I/O Address and corresponding
IRQx. While choosing proper I/O Address, be sure not to cause Address conflict with other I/O
devices.
Onboard Parallel Mode: Choose SPP, EPP/SPP, ECP, ECP/EPP Mode. Make proper
selection with the attached printer port device.
ECP Mode Use DMA: Choose “1” or “3” to select the DMA channel used for the ECP device.
This item is shown if the Onboard Parallel Mode is chosen as “ECP” or “ECP/EPP” option.
Parallel Port EPP Type: Choose “EPP1.7” or “EPP1.9”, which is used to configure the EPP
using either EPP1.7 or 1.9 timing specification. This item is shown if the Parallel Mode is