14
TURNING ON/OFF
The Transmitter is always in a permanent sleep state. It is
only ON when a button is being pressed and does not
need to be turned off by the user. If the Transmitter does
not activate, make sure you have a good battery installed.
Turning the Collar Unit ON/OFF:
Turning the Collar Unit ON and OFF uses the same
procedure:
1. Hold the Transmitter Magnet Indicator (
red dot
)
directly against the Magnetic Activation Switch
(
small bump
) on the side of the Collar Unit.
2. The SmartLED Indicator will light solid for a
second and then start flashing. Remove the
Transmitter from the Collar Unit when the
SmartLED light begins to flash.
If the Collar Unit has been turned ON, the SmartLED will
flash approximately every other second. If the Collar Unit
has been turned OFF, the SmartLED will no longer be
flashing.
NOTE
If the LED on the Transmitter flashes
red
rapidly after any
button is pressed, the 9V battery will need to be replaced.
If the SmartLED on the Collar Unit double-flashes
red
every other second while ON, the unit will need to be re-
charged. If this happens soon after a full charging ses-
sion, the rechargeable batteries in the Collar Unit may
need to be replaced.
NOTE:
If the collar unit is not responding to any signals
from the transmitter, the collar may need to be repro-
grammed to the transmitter (see
page 16
).