DT SWISS D 232, Техническое руководство

Страница: 40 / 41

40
FITTING THE SADDLE AND SEAT CLAMP
1. Using a 5 mm hex key, unscrew the two seat clamp screws leaving a few screw turns still engaged
in the barrel nuts.
2. Lift the upper seat clamp and pull out the lower saddle clamp to the side.
3. Lift the upper seat clamp, tilt the saddle to the side and push in the first saddle brace underneath
the upper seat clamp (A).
4. Tilt the saddle over the upper seat clamp, and attach the saddle so that both saddle braces lie
below the upper seat clamp (B).
5. Pull up the upper seat clamp and the saddle, and push the lower seat clamp in underneath the
saddle (C) from the side.
6. Tighten the seat clamp screws alternately until the desired saddle tilt has been adjusted.
→ When tightening the seat clamp screws, make sure that the barrel nuts are not twisted and lie
in the recesses of the upper saddle clamp.
7. Tighten the seat clamp screws to a torque of 5 Nm.
→ If you are fitting a saddle with carbon braces, the maximum torque may be lower. Observe the
saddle manufacturer’s user manual!
→ If the seat clamp screws should loosen slightly during the ride, a medium thread lock can be
used.
C
A
B