11
240 Oversize [screwed end caps]
5. Put the disassembly tool onto the axle.
6. Put the installation cylinder onto the bearing.
→
The disassembly tool centers the installation
cylinder on the axle.
7. Tap the bearing into the hub shell with slight
hammer strokes.
8.
The lower installation cylinder must rest on a flat
surface.
9. Remove the installation cylinder from the hub.
10. Fit the non drive side of the hub onto one of the
two installation cylinders.
11. Place lightly greased ball bearing on the axle on
the drive side.
12. Drive the second bearing into the hub shell with
slight hammer strokes.
→
The lower installation cylinder must rest on a
flat surface.
13. Remove both installation cylinders from the hub.
