Version: 1.0
Safety Instructions
1. Read these safety instructions
carefully.
2. Keep this User's Manual for later reference.
3. Disconnect this equipment from any DC outlet before cleaning.
4. For plug-in equipment, the power outlet socket must be located near the equipment and must be easily
accessible.
5. Keep this equipment away from humidity.
6. Put this equipment on a reliable surface during installation. Dropping it or letting it fall may cause damage.
7. Make sure the voltage of the power source is correct before connecting the equipment to the power outlet.
8. Position the power cord so that people cannot step on it. Do not place anything over the power cord.
9. All cautions and warnings on the equipment should be noted.
10. If the equipment is not used for a long time, disconnect it from the power source to avoid damage by
transient over voltage.
11. Never pour any liquid into an opening. This may cause fire or electrical shock.
12. Never open the equipment. For safety reasons, the equipment should be opened only by qualified service
personnel.
13. If one of the following situations arises, get the equipment checked by service personnel:
a. The power cord or plug is damaged.
b. Liquid has penetrated into the equipment.
c. The equipment has been exposed to moisture.
d. The equipment does not work well, or you cannot get it to work according to the user's manual.
e. The equipment has been dropped and damaged.
f. The equipment has obvious signs of breakage.
14. Environmental conditions:
Temperature
Transportation: -20°C
– 60°C ; Operation: 0°C – 40°C; Storage: -20°C – 60°C
Humidity
Transportation: 0%
– 90%; Operation:0% – 90%; Storage: 0% – 90%
Atmospheric
Pressure
Transportation: 70,0 kPa to 106,0 kPa; Operation: 70,0 kPa to 106,0 kPa; Storage: 70,0 kPa to 106,0 kPa
15. If your computer is losing dramatic time or the BIOS configuration reset to default, the backup battery has
no power.
Caution
1. Do not replace battery yourself. Please contact a qualified technician or your
retail.
2 .The Computer is provided with a battery-powered real-time clock circuit. There
is a danger of explosion if battery is incorrectly replaced. Replace only with same
or equivalent type recommended by the manufacture. Discard used batteries
according to the manufacturer’s instructions.
Caution
1. Ne pas remplacer vous-même. Veuillez contacter un technicien qualifié ou
votre commerce de détail.
2 . L'ordinateur est fourni avec une pile de l'horloge en temps réel du circuit. Il y
a un risque d'explosion si la batterie est remplacée de manière incorrecte.
Remplacez-la uniquement par une batterie de type identique ou équivalent
recommandé par le fabricant. Jetez les piles usées conformément aux
instructions du fabricant.
16. CLASSIFICATION:
•
Supply Class I adapter
•
No applied part
•
IPX0
•
Continuous Operation
•
Not AP or APG category
17. Disconnect device: Appliance inlet of Power Adapter, please do not to position the Power Adapter so that it
is difficult to operate the disconnection device.
18. Follow the national requirement to dispose unit.
19. Maintenance: to properly maintain and clean the surfaces, use only the approved products or clean with a
dry applicator.
20. Contact information:
DT Research, Inc
2000 Concourse Drive, San Jose, CA 95131, U.S.A
