DSPeaker Anti-Mode X4, Руководство пользователя

Страница: 8 / 24

TM
O
WNER
'
S
M
ANUAL
The measurement process is designed to be resilient against background noise, but it can be
beneficial to choose a moment when the listening room is relatively quiet. It is also a good idea
to turn off any noisy equipment such as air conditioning for the duration of the measurements.
Before the calibration

Set up the supplied microphone stand. Attach the microphone to the stand and connect
the microphone cable to the microphone. Adjust the stand so that the microphone is at
the center of the primary listening location, at about ear height.

If your system features subwoofer(s) that have adjustable low-pass filters, it is good to
disable them, or set the cut-off frequency to their maximum value.

Make sure your active speakers or power amplifiers and/or subwoofers are connected to
the correct outputs and turned on.

It is good to adjust the gain of all connected speakers so that the main speakers and
subwoofers are approximately equally loud.
Running the calibration

Turn on the Anti-Mode X4 unit, wait a few seconds until the boot sequence finishes.

If you have not yet chosen a language, you are prompted to choose one now.

Plug the microphone cord into the connector located at the front panel. The calibration
menu opens automatically.
Notice: you can cancel the calibration at any time by unplugging the microphone cable.

Select typical calibration from the menu by rotating the control wheel and click the
wheel button when the item labeled “Typical” is highlighted.

Rotate the wheel to select a speaker configuration that best matches the connected
audio equipment. You can find more information about the calibration modes further in
this manual. Click the wheel button to proceed.

Adjust calibration volume by rotating the wheel or using the remote controller until the
signal is clearly audible. Click the wheel button to start the calibration process.

When the calibration process has finished, unplug the microphone.
Congratulations, your system has been optimized! Now it is a good time to put on some of your
favorite music and enjoy the improved sound.
Notice : The automatic calibration process targets a balanced overall sound, with slightly
elevated response towards the low bass region. The response can be adjusted in multiple ways
to suit your personal taste. You can read more about sound profiles and shaping the sound next.
Rev. 1.0 2018-03-14 Page 8 (24)