Troubleshooting
96M4281o User’s Manual
5-5
AT Power Setting
This section will introduce you how to quickly and appropriately set up AT power
on your system.
Step 1: Please adjust AT/ATX Jumper on JP6 to short 1-3, 2-4 pins, then it can
support AT power scheme. (Figure 5-8)
Figure 5-8
Note:
If current Power setting is at ATX mode, please clean CMOS first before adjusting
Power setting to AT mode. Otherwise, system would not boot up properly.
Step 2: Remove 4 pins power cable, and then put a jumper back on pin 3 (PS-ON)
and pin 4 (GND) of backplane ATX P/S control connector. (Figure 5-9)
Figure 5-9
