13
DESIGNED SECURITY INC
800-272-3555 www.dsigo.com
1402 Hawthorne Street Bastrop, Texas 78602 Fax 512 321 9181 Email: [email protected]
INS-8900-151110
After planning for Layout and Orientation is complete:
BOLLARD UNCRATING AND MOVING
Open crate to access Bollard.
Each removed Cover should be carefully placed aside to avoid marring
finish or damage to Corian. Lay End Covers on their side as they are
top heavy.
Remove the two Phillips screws at the top of each End Cover, then tilt
to remove. Disconnect cable from Graphic Display. Repeat for opposite
End.
Remove two Phillips screws on top of Lower Cover. Unsnap cover from
the bottom of Bollard. Repeat for opposite side.
Remove 2 bolts from each End Base and 4 bolts from Center Base.
that attach the bollard to the crate.
Have anchor points ready with hardware necessary to secure bollard to
floor or plate.
With a person at each end of Bollard, lift from under the stainless steel
Top Cover (attached).
Bollards are top-heavy, use caution during transport and storage to
avoid damage from tipping.
Secure to floor as soon as possible, avoid leaving the Bollard free
standing while unattended.
PANEL INSTALLATION STEPS
End Cover: fit over base at an angle, re-attach cable to Graphic Display, tilt into vertical position, attach with screws.
Lower Cover: secure with screws, then snap into mating Lower cover.
NOTE:
When anchoring the Bollard, 1/4” bolts with fender washers and lock washers are recommended.
UNPACKING
SS Top Cover Lifting Points
Lower Cover Center Base
End Cover/End Base
Tailgate Sensor Cover
Presence Sensor Cover
COVERS ASSEMBLY REFERENCE
(only remove End and Lower covers to uncrate)
Содержание ES8900
